Steady pressure and a medium speed will drill the hole without overheating and damaging the drill bit.Once the hole is started, you can increase the drill speed, but don’t run it at full speed.Go slowly, particularly at first, to make sure the hole ends up where you want it.The tape not only makes it easier to mark the wall but also helps to keep the drill bit from skidding when starting the hole. Try to locate the hardware close to the center of the tile – the edges crack more easily.For accessories such as towel bars with two mounting brackets, use a level to make sure both sets of holes align.It’s easier to accurately mark the hole location on tape than on tile. First, adhere masking tape to the wall in the area where you’ll drill.They say to measure twice and cut once, but given the consequences of drilling a hole in a tile wall in the wrong place, it’s a good idea to measure three times and drill once. While that sounds expensive, a ¼ inch diamond tipped tip costs under $20, and a carbide bit of the same size can be had for less than $10. Ceramic tile can be drilled with a carbide bit, while glass and porcelain call for a diamond-tipped bit. Standard drill bits don’t work on tile, but not to worry. Step 2: Have the right bit for ceramic tile Porcelain tile looks a lot like regular ceramic tile, but it’s much harder.Glass tile is used more as an accent and has only been around for 15 years or so.Glazed ceramic tile is the most common, what you’ll find in almost every older home, and the easiest to drill through.In general, there are three kinds of tile: Steps for Drilling Through Tile Step 1: Figure out what kind of tile you have You also need to drill through the substrate behind it in a way that doesn’t cause damage which would prevent the wall anchor from working. In most cases, these bath accouterments will be mounted using wall anchors, so getting through the tile is only part of the job. Almost anything that mounts to the wall-from installing hardware for toilet paper rolls and soap dishes to a new medicine cabinet-is going to require drilling through tile. The centre drill bit will pierce the tile before the hole saw, so you simply need to line up the mark on the other side.Whether it’s a newly tiled bathroom or an existing one, having to put holes in tiled walls is a common task. If you are drilling into tile that has not yet been laid, turn over the tile before drilling all the way through and continue drilling from the other side. The tile should be kept wet at all times. Remove the masking tape and wet the tile with cold water to prevent the hole saw from overheating. Drill slowly and steadily, being sure to distribute light and even pressure over the surface of the hole saw. If you are using a hole saw, mark the tile first with the centre bit and the hole saw. Be sure to keep your drill absolutely straight when drilling. If you are drilling using a basic drill bit, drill at a slow and steady rate. The role of the tape is to prevent the drill from slipping and to protect the tile. Next, apply some masking tape over the area you want to drill and use a marker pen to mark out your drill holes. Identify where you need to drill your holes by taking measurements or by positioning the object you want to install against the wall. Never attempt to drill a tile surface in hammer mode. You will need to complete the task using a drill equipped with a variable speed drive. Usually, the tile to be drilled is already in place so there is little to no room for error. As mentioned, just about any DIYer should be up to the task of drilling through tiling to install a tap, light switch, electrical socket, spotlight, shelf and so on.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |